Document Type
Conference Proceeding
Publication Date
5-24-2016
Abstract
A capacitive humidity-sensing device was created by thermal evaporation of 99.999% aluminum. The substrate used for the coating was etched double-sided printed circuit board. The etched printed circuit board serves as the dielectric of the capacitor while the aluminum thin films deposited on either side serve as the plates of the capacitor. The capacitance was measured before and after exposure to humidity. The device was then calibrated by comparing the readings of capacitance with that of the relative humidity sensor of the Vernier LabQuest2. It was found that there is a linear relationship between the capacitance and relative humidity given by the equation C=1.418RH+29.139 where C is the capacitance and RH is the relative humidity. The surface of the aluminum films is porous and it is through these pores that water is adsorbed and capillary condensation occurs, thereby causing the capacitance to change upon exposure to humidity.
Recommended Citation
Lee, J. A. L., & Culaba, I. B. (2016). Fabrication of a capacitive relative humidity sensor using aluminum thin films deposited on etched printed circuit board. MATEC Web of Conferences, 59, 01011. https://doi.org/10.1051/matecconf/20165901011
